IB-E01 2-Zone Controller Networked Cards ITOH DENKI Vietnam | ITOH DENKI Việt Nam
Applicable Models: PM486FS, PM486FE, PM486FP, PM570FE, PM605FE, PM635FS

Features:
- Controls up to two (2) Power Mollers both with and without brake models*
- Direct connection for two (2) photo-sensors that power and receive the output signal
- Custom programmable ladder logic for fine tuning your specific application
- Automatically adjusts to NPN or PNP inputs for both photo-sensors and discrete inputs
- I/O device equipping three (3) discrete inputs and five (5) discrete outputs
- Establish I/O connection to Rockwell's software and control platforms through E/IP
- Local and remote control are available
- Two (2) port Ethernet switch built upon Rockwell Automation's switch technology
- LED status / error indicators
- Motor pulse counting through local logic
- EtherNet/IP CONFORMANCE TESTED™
- Wire side connectors are available from various sources. They are not provided as standard.
MOTOR POWER [CN1]: WAGO 231-302 / 026-000
COMMUNICATION [CN404 & CN405]: RJ45
SENSOR [CN303 & CN304]: WAGO 733-104
EXTERNAL INPUT [CN301]: WAGO 734-204
SIGNAL OUTPUT [CN302]: WAGO 734-206
*Non-brake model rollers must use 10-pin connector

Protection
- Thermal overload 185° F
- (90° C) on PCB
- Thermal overload 221ºF (105ºC) in the motor
- 6.3A fuse for each motor
- Diode for protection from incorrect wiring
Environment
- Ambient Temperature: 4~104º F (-20~40ºC)
- < 90% Relative Humidity
- (No condensation)
- No Corrosive Gases
- Vibration < 1.0G
Technical Support Information
- IB-E01 and ICE Manual REV201404-001
- IB-E01 Product Sheet
- Itoh Configurator for EtherNet/IP (ICE)
- Description: Programming and configuration software for the IB-E01 dual motor driver
- Sample Project for ICE
- Description: 2 Zone Non-Touch Accumulation logic and IB-E01 configuration ready to use
- Add-On-Profile for RSLogix 5000 v15 through Studio 5000 v21
- Description: Configuration and I/O tags for the IB-E01
- Please refer to the Basic Module Information linked under the “Vendor” tab
- Sample Routine and Add-On-Instruction for IB-E01
- Description: Packaged routine, logic, and configuration for basic 2 Zone Non-Touch Accumulation
- IB-E01 EDS File
- Description: Electronic Data Sheet
Không có nhận xét nào:
Đăng nhận xét