Models Applicable

PM486FS, PM486FE, PM486FP, PM570FE,PM605FE, PM635FS

Specification Document

- Provides thermal protection for both Power Moller and driver card

- Two LED’s to identify type of error

- Error output signal for self diagnosis

- Dynamic brake and servo brake control

- Variable speed by rotary switch or external voltage input

- Direction control by DIP switch or external signal input

- Adjustable acceleration and deceleration time (0-2.5s)

- Switch for automatic or manual recovery of back EMF error and thermal overload device

- Forcibly stops the motor if there is a motor lock, back EMF, or thermal overload occurs

- Includes mounting hardware and wiring connector

- Two (2) M4 x 15 phillips pan head mounting screws and nuts

- Connectors for power and control are:

Power: WAGO #734-102 (Included)

Control: WAGO #733-105 (Included)

Electrical	• 24V DC ±10% input • Battery • Power Supply: fullwave rectified with smoothed current and < 10% Ripple • Power ON delay < 1s • 4A locking current • Input signal level for activation • 0V (3V or less) for NPN • 24V (18V or greater) for PNP • Output (Error and Motor Pulse) signals • Open collector 24V, 25mA or less • NPN • PNP (selectable for Error only) • Brake model only • 0.2s delay between stop signal and mechanical brake reaction • 0.2A brake current @24V (< 0.1s) • Brake coil is active (disengaging brake) while motor is running
Brake	• Dynamic (Electric-Both models) • Mechanical (CB-016BS7 only)
Protection	• Thermal protection reaction • 85° C (185° F) on the PCB • 105° C (221° F) in the motor • Built-in 5A fuse for power supply protection • Built-in diode for incorrect wiring protection
Applicable Environment	• Temperature 0~40° C (32~104° F) • < 90% Relative Humidity (No condensation) • No corrosive gas • Vibration < 0.5G
Power Source	• 24VDC Battery or 24VDC Power Supply• Battery or fullwave rectified with smoothed current < 10% Ripple